HomeTOORAK TIMES NEWSPAPERAROUND THE HOUSEReplace your hot water system before it dies, not after

Replace your hot water system before it dies, not after

Most hot water systems get replaced in a hurry. Someone gets a cold shower, a plumber comes out, and the household takes whatever unit can go in that day. It works, but it’s the worst way to make a decision you’ll live with for the next ten years or more.

If yours is getting on, a bit of homework now gives you time to compare options, check what help is available with the cost, and book the job when it suits you.

How old is it?

Look for the compliance plate or sticker on the side of the unit. It usually shows a manufacture date or a serial number. If it doesn’t, the installer’s sticker often has the install date.

As a rough guide from what I see on jobs around Melbourne:

  • Gas storage tanks: 8 to 12 years
  • Electric storage tanks: 10 to 15 years
  • Continuous-flow gas: 12 years, and often well past that if it’s been descaled
  • Heat pumps: 10 to 15 years, depending a lot on the compressor

Warranties are typically 5 to 10 years. Age alone doesn’t mean a unit is about to fail, but a storage tank over 12 years old with any sign of leaking is worth planning around.

Signs it’s on the way out

  • Rusty or discoloured water from the hot taps only
  • Water pooling around the base of the tank
  • The relief valve running constantly, rather than dripping a little while it heats
  • Running out of hot water sooner than it used to
  • Rumbling or popping from a storage tank
  • A pilot light that keeps going out

A tank leaking from the body can’t be repaired. Valves, thermocouples and elements can, and on a unit under about eight years old a repair is usually the better call.

Size it for how you live now

The household that chose the current unit might not be the one living with it now. Kids turn into teenagers who take long showers. A renovation adds an ensuite or a big freestanding bath.

In bigger homes the real question is peak demand: how many showers run at once on a busy morning. A storage tank sized for two people will run out. A continuous-flow unit doesn’t run out in the same way, but a large one needs enough gas to fire at full rate, and in some older homes the gas pipe needs upsizing, or the regulator at the meter does. Find that out before you buy the unit, not on install day.

Long pipe runs are the other thing in larger houses. If the far bathroom takes ages to run hot, that’s distance, not the unit, and a new system won’t fix it on its own. Raise it when you get the quote.

Gas, electric or heat pump

There’s no single right answer, but things have shifted.

Since 2024, new homes in Victoria that need a planning permit can’t be connected to gas, and the rules for existing homes have been changing too, so check what applies at the time you replace. A lot of people use a replacement as the moment to switch to a heat pump. They’re very efficient to run, and the Victorian Energy Upgrades program often takes a chunk off the price. The amounts change, so get current figures before you commit.

With a heat pump, think about:

  • Where it goes. It has a compressor like an air conditioner, so it shouldn’t sit under a bedroom window or right next to the neighbour’s.
  • Space. It needs an outdoor spot with decent airflow.
  • Power. The electrical side may need an electrician as well.

Gas continuous flow still suits plenty of homes, especially where the gas supply is already big enough and there’s no good spot for a heat pump.

What the install should include

Check that these are on the quote:

  • A tempering valve, so hot water at the bathroom outlets is limited to 50°C. It’s required on new installations in Victoria.
  • A relief valve drain that runs somewhere visible and safe, not into a wall cavity where a leak can go unnoticed.
  • A storage tank set to keep water at 60°C or above, which keeps Legionella under control.
  • A Compliance Certificate from the licensed plumber, and from the gasfitter for any gas work.

Look after the new one

Two small jobs make a real difference to how long a storage tank lasts. Lift the relief valve lever every six months to make sure it isn’t stuck. And have the anode checked at around five years. It’s a rod inside the tank that corrodes so the tank wall doesn’t, and replacing it on an otherwise healthy tank can add years.

If you only do one thing this week

Find the date on your unit. If it’s past ten years, get a quote for replacing your hot water system while it’s still working. You’ll have time to choose properly, and nobody starts the day with a cold shower.


About the author

Alister Williams is a licensed plumber and Type A gasfitter (BPC 103414) with around 20 years’ experience in Australia and overseas. He runs Prime Plumbing & Gasfitting, working across Toorak and Melbourne’s east and south-east.

- Advertisment -[the_ad_group id="28692"]